arm64: dts: rockchip: move QCA6174A wakeup pin into its USB node
Currently, we don't coordinate BT USB activity with our handling of the BT out-of-band wake pin, and instead just use gpio-keys. That causes problems because we have no way of distinguishing wake activity due to a BT device (e.g., mouse) vs. the BT controller (e.g., re-configuring wake mask before suspend). This can cause spurious wake events just because we, for instance, try to reconfigure the host controller's event mask before suspending. We can avoid these synchronization problems by handling the BT wake pin directly in the btusb driver -- for all activity up until BT controller suspend(), we simply listen to normal USB activity (e.g., to know the difference between device and host activity); once we're really ready to suspend the host controller, there should be no more host activity, and only *then* do we unmask the GPIO interrupt. This is already supported by btusb; we just need to describe the wake pin in the right node. We list 2 compatible properties, since both PID/VID pairs show up on Scarlet devices, and they're both essentially identical QCA6174A-based modules. Also note that the polarity was wrong before: Qualcomm implemented WAKE as active high, not active low. We only got away with this because gpio-keys always reconfigured us as bi-directional edge-triggered. Finally, we have an external pull-up and a level-shifter on this line (we didn't notice Qualcomm's polarity in the initial design), so we can't do pull-down. Switch to pull-none. Signed-off-by:Brian Norris <briannorris@chromium.org> Reviewed-by:
Matthias Kaehlcke <mka@chromium.org> Signed-off-by:
Marcel Holtmann <marcel@holtmann.org>
parent
7d19261b
Please register or sign in to comment