Skip to content
  1. Jan 10, 2017
    • Wenyou Yang's avatar
      ARM: dts: at91: add dts file for sama5d36ek CMP board · 5347d806
      Wenyou Yang authored
      
      
      The sama5d36ek CMP board is the variant of sama5d3xek board.
      It is equipped with the low-power DDR2 SDRAM, PMIC ACT8865 and
      some power rail. Its main purpose is used to measure the power
      consumption.
      The difference of the sama5d36ek CMP dts from sama5d36ek dts is
      listed as below.
       1. The USB host nodes are removed, that is, the USB host is disabled.
       2. The gpio_keys node is added to wake up from the sleep.
       3. The LCD isn't supported due to the pins for LCD are conflicted
          with gpio_keys.
       4. The adc0 node support the pinctrl sleep state to fix the over
          consumption on VDDANA.
      
      As said in errata, "When the USB host ports are used in high speed
      mode (EHCI), it is not possible to suspend the ports if no device is
      attached on each port. This leads to increased power consumption even
      if the system is in a low power mode." That is why the the USB host
      is disabled.
      
      Signed-off-by: default avatarWenyou Yang <wenyou.yang@atmel.com>
      Acked-by: default avatarNicolas Ferre <nicolas.ferre@atmel.com>
      Signed-off-by: default avatarAlexandre Belloni <alexandre.belloni@free-electrons.com>
      5347d806
  2. Dec 06, 2016
  3. Nov 26, 2016
  4. Nov 24, 2016
  5. Nov 22, 2016
  6. Nov 19, 2016
  7. Nov 17, 2016
  8. Nov 16, 2016
  9. Nov 15, 2016
    • Alexandre TORGUE's avatar
      ARM: dts: Add STM32F746 MCU and STM32746g-EVAL board · ec2f9b10
      Alexandre TORGUE authored
      
      
      The STMicrolectornics's STM32F746 MCU has the following main features:
       - Cortex-M7 core running up to @216MHz
       - 1MB internal flash, 320KBytes internal RAM (+4KB of backup SRAM)
       - FMC controller to connect SDRAM, NOR and NAND memories
       - Dual mode QSPI
       - SD/MMC/SDIO support
       - Ethernet controller
       - USB OTFG FS & HS controllers
       - I2C, SPI, CAN busses support
       - Several 16 & 32 bits general purpose timers
       - Serial Audio interface
       - LCD controller
       - HDMI-CEC
       - SPDIFRX
      
      Signed-off-by: default avatarAlexandre TORGUE <alexandre.torgue@st.com>
      ec2f9b10
    • Peter Chen's avatar
      ARM: dts: imx6ull: add imx6ull support · c201369d
      Peter Chen authored
      It is the 10th processor in the well-known imx6 series, and derived
      from imx6ul but cost optimized. The more information about imx6ull
      can be found at:
      
      http://www.nxp.com/products/microcontrollers-and-processors/
      
      
      arm-processors/i.mx-applications-processors/i.mx-6-processors
      /i.mx6qp/i.mx-6ull-single-core-processor-with-arm-cortex-a7-core
      :i.MX6ULL
      
      imx6ul.dtsi is the SoC common stuff for both imx6ul and imx6ull;
      imx6ul-14x14-evk.dts is the board common stuff for both imx6ul
      and imx6ull 14x14 evk. In this patch, for SoC part, the
      imx6ull.dtsi includes imx6ul.dtsi; for board part, imx6ull-14x14-evk.dts
      includes imx6ul-14x14-evk.dts.
      
      Signed-off-by: default avatarPeter Chen <peter.chen@nxp.com>
      Signed-off-by: default avatarShawn Guo <shawnguo@kernel.org>
      c201369d
  10. Nov 10, 2016
  11. Nov 09, 2016
  12. Nov 04, 2016
  13. Nov 02, 2016
  14. Nov 01, 2016
  15. Oct 24, 2016
  16. Oct 22, 2016
  17. Oct 20, 2016
  18. Oct 19, 2016
  19. Oct 16, 2016
  20. Sep 14, 2016
  21. Sep 12, 2016