media: ipu-bridge: Add a runtime-pm device-link between VCM and sensor

In most cases when a VCM is used there is a single integrated module
with the sensor + VCM + lens. This means that the sensor and VCM often
share regulators and possibly also something like a powerdown pin.

In the ACPI tables this is modelled as a single ACPI device with
multiple I2cSerialBus resources.

On atomisp devices the regulators and clks are modelled as ACPI
power-resources, which are controlled by the (ACPI) power state
of the sensor. So the sensor must be in D0 power state for the VCM
to work.

To make this work add a device-link with DL_FLAG_PM_RUNTIME flag
so that the sensor will automatically be runtime-resumed whenever
the VCM is runtime-resumed.

This requires the probing of the VCM and thus the creation of the VCM
I2C-client to be delayed till after the sensor driver has bound.

Move the instantiation of the VCM I2C-client to the v4l2_async_notifier
bound op, so that it is done after the sensor driver has bound; and
add code to add the device-link.

This fixes the problem with the shared ACPI power-resources on atomisp2
and this avoids the need for VCM related workarounds on IPU3 / IPU6.

E.g. until now the dw9719 driver needed to get and control a Vsio
(V sensor IO) regulator since that needs to be enabled to enable I2C
pass-through on the PMIC on the sensor module. So the driver was
controlling this regulator even though the actual dw9719 chip has no
Vsio pin / power-plane.

This also removes the need for ipu_bridge_init() to return
-EPROBE_DEFER since the VCM is now instantiated later.

Reviewed-by: Andy Shevchenko <andy@kernel.org>
Reviewed-by: Daniel Scally <dan.scally@ideasonboard.com>
Tested-by: Daniel Scally <dan.scally@ideasonboard.com>
Signed-off-by: Hans de Goede <hdegoede@redhat.com>
Signed-off-by: Sakari Ailus <sakari.ailus@linux.intel.com>
Signed-off-by: Mauro Carvalho Chehab <mchehab@kernel.org>