PCI: pciehp: Deduplicate presence check on probe & resume

On driver probe and on resume from system sleep, pciehp checks the
Presence Detect State bit in the Slot Status register to bring up an
occupied slot or bring down an unoccupied slot.  Both code paths are
identical, so deduplicate them per Mika's request.

On probe, an additional check is performed to disable power of an
unoccupied slot.  This can e.g. happen if power was enabled by BIOS.
It cannot happen once pciehp has taken control, hence is not necessary
on resume:  The Slot Control register is set to the same value that it
had on suspend by pci_restore_state(), so if the slot was occupied,
power is enabled and if it wasn't, power is disabled.  Should occupancy
have changed during the system sleep transition, power is adjusted by
bringing up or down the slot per the paragraph above.

To allow for deduplication of the presence check, move the power check
to pcie_init().  This seems safer anyway, because right now it is
performed while interrupts are already enabled, and although I can't
think of a scenario where pciehp_power_off_slot() and the IRQ thread
collide, it does feel brittle.

However this means that pcie_init() may now write to the Slot Control
register before the IRQ is requested.  If both the CCIE and HPIE bits
happen to be set, pcie_wait_cmd() will wait for an interrupt (instead
of polling the Command Completed bit) and eventually emit a timeout
message.  Additionally, if a level-triggered INTx interrupt is used,
the user may see a spurious interrupt splat.  Avoid by disabling
interrupts before disabling power.  (Normally the HPIE and CCIE bits
should be clear on probe, but conceivably they may already have been
set e.g. by BIOS.)

Signed-off-by: Lukas Wunner <lukas@wunner.de>
Signed-off-by: Bjorn Helgaas <bhelgaas@google.com>
Reviewed-by: Mika Westerberg <mika.westerberg@linux.intel.com>