mtd: rawnand: gpmi: Add large oob bch setting support

The code change proposes a new way to set bch geometry for large oob
NAND (oobsize > 1KB). In this case, previous implementation can NOT
guarantee the bad block mark always locates in data chunk, so we need a
new way to do it. The general idea is,

1.Try all ECC strength from the maximum ecc that controller can support
  to minimum value required by NAND chip, any ECC strength makes the
  BBM locate in data chunk can be eligible.

2.If none of them works, using separate ECC for meta, which will add
  one extra ecc with the same ECC strength as other data chunks. This
  extra ECC can guarantee BBM located in data chunk, also we need to
  check if oob can afford it.

Signed-off-by: Han Xu <han.xu@nxp.com>
Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
Link: https://lore.kernel.org/linux-mtd/20220412025246.24269-6-han.xu@nxp.com