net: phy: micrel: Add support for PTP_PF_PEROUT for lan8841

commit 6ab8d5663412815f8af7467a910d1c43168ebfe6 from
https://github.com/linux4microchip/linux.git

 linux-6.1-mchp+fpga

Lan8841 has 10 GPIOs and it has 2 events(EVENT_A and EVENT_B). It is
possible to assigned the 2 events to any of the GPIOs, but a GPIO can
have only 1 event at a time.
These events are used to generate periodic signals. It is possible to
configure the length, the start time and the period of the signal by
configuring the event.
Currently the SW uses only EVENT_A to generate the perout.

These events are generated by comparing the target time with the PHC
time. In case the PHC time is changed to a value bigger than the target
time + reload time, then it would generate only 1 event and then it
would stop because target time + reload time is small than PHC time.
Therefore it is required to change also the target time every time when
the PHC is changed. The same will apply also when the PHC time is
changed to a smaller value.

This was tested using:
testptp -L 6,2
testptp -p 1000000000 -w 200000000

Signed-off-by: Horatiu Vultur <horatiu.vultur@microchip.com>
Link: https://lore.kernel.org/r/20230307214402.793057-1-horatiu.vultur@microchip.com


Signed-off-by: Jakub Kicinski <kuba@kernel.org>
Signed-off-by: Saravanan.K.S <saravanan.kadambathursubramaniyam@windriver.com>