s390/ap: rearm APQNs bindings complete completion

The APQN bindings complete completion was used to reflect
that 1st the AP bus initial scan is done and 2nd all the
detected APQNs have been bound to a device driver.
This was a single-shot action. However, as the AP bus
supports hot-plug it may be that new APQNs appear reflected
as new AP queue and card devices which need to be bound
to appropriate device drivers. So the condition that
all existing AP queue devices are bound to device drivers
may go away for a certain time.

This patch now checks during AP bus scan for maybe new AP
devices appearing and does a re-init of the internal completion
variable. So the AP bus function ap_wait_apqn_bindings_complete()
now may block on this condition variable even later after
initial scan is through when new APQNs appear which need to
get bound.

This patch also moves the check for binding complete invocation
from the probe function to the end of the AP bus scan function.
This change also covers some weird scenarios where during a
card hotplug the binding of the card device was sufficient for
binding complete but the queue devices where still in the
process of being discovered.

As of now this change has no impact on existing code. The
behavior change in the now later bindings complete should not
impact any code (and has been tested so far). The only
exploiter is the zcrypt function zcrypt_wait_api_operational()
which only initial calls ap_wait_apqn_bindings_complete().

However, this new behavior of the AP bus wait for APQNs bindings
complete function will be used in a later patch exploiting
this for the zcrypt API layer.

Signed-off-by: Harald Freudenberger <freude@linux.ibm.com>
Reviewed-by: Holger Dengler <dengler@linux.ibm.com>
Signed-off-by: Heiko Carstens <hca@linux.ibm.com>