usb: dwc3: core: Do not perform GCTL_CORE_SOFTRESET during bootup

stable inclusion
from stable-v5.10.137
commit d376ca67168316d5e004268600b8c978e1b87cff
category: bugfix
bugzilla: https://gitee.com/openeuler/kernel/issues/I60PLB

Reference: https://git.kernel.org/pub/scm/linux/kernel/git/stable/linux.git/commit/?id=d376ca67168316d5e004268600b8c978e1b87cff



--------------------------------

[ Upstream commit 07903626 ]

According to the programming guide, it is recommended to
perform a GCTL_CORE_SOFTRESET only when switching the mode
from device to host or host to device. However, it is found
that during bootup when __dwc3_set_mode() is called for the
first time, GCTL_CORESOFTRESET is done with suspendable bit(BIT 17)
of DWC3_GUSB3PIPECTL set. This some times leads to issues
like controller going into bad state and controller registers
reading value zero. Until GCTL_CORESOFTRESET is done and
run/stop bit is set core initialization is not complete.
Setting suspendable bit of DWC3_GUSB3PIPECTL and then
performing GCTL_CORESOFTRESET is therefore not recommended.
Avoid this by only performing the reset if current_dr_role is set,
that is, when doing subsequent role switching.

Fixes: f88359e1 ("usb: dwc3: core: Do core softreset when switch mode")
Signed-off-by: Rohith Kollalsi <quic_rkollals@quicinc.com>
Link: https://lore.kernel.org/r/20220714045625.20377-1-quic_rkollals@quicinc.com


Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Signed-off-by: Sasha Levin <sashal@kernel.org>
Signed-off-by: Zheng Zengkai <zhengzengkai@huawei.com>
Reviewed-by: Wei Li <liwei391@huawei.com>