scsi: hisi_sas: Ensure all enabled PHYs up during controller reset

driver inclusion
category: bugfix
bugzilla: https://gitee.com/openeuler/kernel/issues/I6V6I1


CVE: NA

----------------------------------------------------------------------

For the controller reset operation, hisi_sas_phy_enable() is executed for
each enabled local PHY, and refresh the port id of each device based on
the latest hisi_sas_phy->port_id after 1 second sleep,
hisi_sas_phy->port_id is configured in the interrupt processing function
phy_up_v3_hw(). However, in directly attached scenario, for some SATA
disks the amount of time for phyup more than 1s sometimes. In this case,
incorrect port id may be configured in hisi_sas_refresh_port_id().
As a result, all the internal IOs fail and disk lost, such as follows:

[10717.666565] hisi_sas_v3_hw 0000:74:02.0: phyup: phy1 link_rate=10(sata)
[10718.826813] hisi_sas_v3_hw 0000:74:02.0: erroneous completion iptt=63
task=00000000c1ab1c2b dev id=200 addr=5000000000000501 CQ hdr: 0x8000007 0xc8003f 0x0
0x0 Error info: 0x0 0x0 0x0 0x0
[10718.843428] sas: TMF task open reject failed  5000000000000501
[10718.849242] hisi_sas_v3_hw 0000:74:02.0: erroneous completion iptt=64
task=00000000c1ab1c2b dev id=200 addr=5000000000000501 CQ hdr: 0x8000007 0xc80040 0x0
0x0 Error info: 0x0 0x0 0x0 0x0
[10718.865856] sas: TMF task open reject failed  5000000000000501
[10718.871670] hisi_sas_v3_hw 0000:74:02.0: erroneous completion iptt=65
task=00000000c1ab1c2b dev id=200 addr=5000000000000501 CQ hdr: 0x8000007 0xc80041 0x0
0x0 Error info: 0x0 0x0 0x0 0x0
[10718.888284] sas: TMF task open reject failed  5000000000000501
[10718.894093] sas: executing TMF for 5000000000000501 failed after 3 attempts!
[10718.901114] hisi_sas_v3_hw 0000:74:02.0: ata disk 5000000000000501 reset failed
[10718.908410] hisi_sas_v3_hw 0000:74:02.0: controller reset complete
.....
[10773.298633] ata216.00: revalidation failed (errno=-19)
[10773.303753] ata216.00: disable device

So the time of waitting for PHYs up is 1s which may be not enough. To
solve the issue, running hisi_sas_phy_enable() in parallel through
async operations and use wait_for_completion_timeout() to wait for PHYs
come up instead of directly sleep for 1 second.

Signed-off-by: Yihang Li <liyihang9@huawei.com>
Signed-off-by: Xiang Chen <chenxiang66@hisilicon.com>
Signed-off-by: xiabing <xiabing12@h-partners.com>