arm64/sve: Leave SVE enabled on syscall if we don't context switch

The syscall ABI says that the SVE register state not shared with FPSIMD
may not be preserved on syscall, and this is the only mechanism we have
in the ABI to stop tracking the extra SVE state for a process. Currently
we do this unconditionally by means of disabling SVE for the process on
syscall, causing userspace to take a trap to EL1 if it uses SVE again.
These extra traps result in a noticeable overhead for using SVE instead
of FPSIMD in some workloads, especially for simple syscalls where we can
return directly to userspace and would not otherwise need to update the
floating point registers. Tests with fp-pidbench show an approximately
70% overhead on a range of implementations when SVE is in use - while
this is an extreme and entirely artificial benchmark it is clear that
there is some useful room for improvement here.

Now that we have the ability to track the decision about what to save
seprately to TIF_SVE we can improve things by leaving TIF_SVE enabled on
syscall but only saving the FPSIMD registers if we are in a syscall.
This means that if we need to restore the register state from memory
(eg, after a context switch or kernel mode NEON) we will drop TIF_SVE
and reenable traps for userspace but if we can just return to userspace
then traps will remain disabled.

Since our current implementation and hence ABI has the effect of zeroing
all the SVE register state not shared with FPSIMD on syscall we replace
the disabling of TIF_SVE with a flush of the non-shared register state,
this means that there is still some overhead for syscalls when SVE is in
use but it is very much reduced.

Signed-off-by: Mark Brown <broonie@kernel.org>
Reviewed-by: Catalin Marinas <catalin.marinas@arm.com>
Reviewed-by: Marc Zyngier <maz@kernel.org>
Link: https://lore.kernel.org/r/20221115094640.112848-8-broonie@kernel.org
Signed-off-by: Will Deacon <will@kernel.org>