Commit 94d66714 authored by Matthias Kaehlcke's avatar Matthias Kaehlcke Committed by Marcel Holtmann
Browse files

Bluetooth: hci_qca: Reduce delay after sending baudrate request for WCN3990 



The current 300ms delay after a baudrate change is extremely long.
For WCN3990 it is sufficient to wait 10ms after the baudrate change
request has been sent over the wire.

Signed-off-by: default avatarMatthias Kaehlcke <mka@chromium.org>
Signed-off-by: default avatarMarcel Holtmann <marcel@holtmann.org>
parent 5364a0b4

drivers/bluetooth/hci_qca.c

+18 −8
Original line number Diff line number Diff line
@@ -59,8 +59,7 @@ 


#define IBS_WAKE_RETRANS_TIMEOUT_MS	100

#define IBS_TX_IDLE_TIMEOUT_MS		2000

#define BAUDRATE_SETTLE_TIMEOUT_MS	300

#define POWER_PULSE_TRANS_TIMEOUT_MS	100

#define CMD_TRANS_TIMEOUT_MS		100



/* susclk rate */

#define SUSCLK_RATE_32KHZ	32768
@@ -964,6 +963,7 @@ static int qca_set_baudrate(struct hci_dev *hdev, uint8_t baudrate) 
{

	struct hci_uart *hu = hci_get_drvdata(hdev);

	struct qca_data *qca = hu->priv;

	struct qca_serdev *qcadev;

	struct sk_buff *skb;

	u8 cmd[] = { 0x01, 0x48, 0xFC, 0x01, 0x00 };
@@ -985,11 +985,21 @@ static int qca_set_baudrate(struct hci_dev *hdev, uint8_t baudrate) 
	skb_queue_tail(&qca->txq, skb);

	hci_uart_tx_wakeup(hu);



	/* wait 300ms to change new baudrate on controller side

	 * controller will come back after they receive this HCI command

	 * then host can communicate with new baudrate to controller

	 */

	msleep(BAUDRATE_SETTLE_TIMEOUT_MS);

	qcadev = serdev_device_get_drvdata(hu->serdev);



	/* Wait for the baudrate change request to be sent */



	while (!skb_queue_empty(&qca->txq))

		usleep_range(100, 200);



	serdev_device_wait_until_sent(hu->serdev,

		      msecs_to_jiffies(CMD_TRANS_TIMEOUT_MS));



	/* Give the controller time to process the request */

	if (qcadev->btsoc_type == QCA_WCN3990)

		msleep(10);

	else

		msleep(300);



	return 0;

}
@@ -1005,7 +1015,7 @@ static inline void host_set_baudrate(struct hci_uart *hu, unsigned int speed) 
static int qca_send_power_pulse(struct hci_uart *hu, bool on)

{

	int ret;

	int timeout = msecs_to_jiffies(POWER_PULSE_TRANS_TIMEOUT_MS);

	int timeout = msecs_to_jiffies(CMD_TRANS_TIMEOUT_MS);

	u8 cmd = on ? QCA_WCN3990_POWERON_PULSE : QCA_WCN3990_POWEROFF_PULSE;



	/* These power pulses are single byte command which are sent