Commit 4cacbe22 authored by Peter Meerwald's avatar Peter Meerwald Committed by David Woodhouse
Browse files

mtd: omap2: fix some typos in comments 



Signed-off-by: default avatarPeter Meerwald <p.meerwald@bct-electronic.com>
Signed-off-by: default avatarArtem Bityutskiy <artem.bityutskiy@linux.intel.com>
Signed-off-by: default avatarDavid Woodhouse <David.Woodhouse@intel.com>
parent bf7a01bf

drivers/mtd/nand/omap2.c

+5 −5
Original line number Diff line number Diff line
@@ -347,7 +347,7 @@ static void omap_nand_dma_callback(void *data) 
}



/*

 * omap_nand_dma_transfer: configer and start dma transfer

 * omap_nand_dma_transfer: configure and start dma transfer

 * @mtd: MTD device structure

 * @addr: virtual address in RAM of source/destination

 * @len: number of data bytes to be transferred
@@ -463,7 +463,7 @@ static void omap_write_buf_dma_pref(struct mtd_info *mtd, 
}



/*

 * omap_nand_irq - GMPC irq handler

 * omap_nand_irq - GPMC irq handler

 * @this_irq: gpmc irq number

 * @dev: omap_nand_info structure pointer is passed here

 */
@@ -1205,7 +1205,7 @@ static int __devinit omap_nand_probe(struct platform_device *pdev) 


	/*

	 * If RDY/BSY line is connected to OMAP then use the omap ready

	 * funcrtion and the generic nand_wait function which reads the status

	 * function and the generic nand_wait function which reads the status

	 * register after monitoring the RDY/BSY line. Otherwise use a standard

	 * chip delay which is slightly more than tR (AC Timing) of the NAND

	 * device and read status register until you get a failure or success
@@ -1287,7 +1287,7 @@ static int __devinit omap_nand_probe(struct platform_device *pdev) 


	info->nand.verify_buf = omap_verify_buf;



	/* selsect the ecc type */

	/* select the ecc type */

	if (pdata->ecc_opt == OMAP_ECC_HAMMING_CODE_DEFAULT)

		info->nand.ecc.mode = NAND_ECC_SOFT;

	else if ((pdata->ecc_opt == OMAP_ECC_HAMMING_CODE_HW) ||