Commit 3d2813fb authored by Uwe Kleine-König's avatar Uwe Kleine-König Committed by Thierry Reding
Browse files

pwm: lpc32xx: Don't modify HW state in .probe() after the PWM chip was registered 



This fixes a race condition: After pwmchip_add() is called there might
already be a consumer and then modifying the hardware behind the
consumer's back is bad. So set the default before.

(Side-note: I don't know what this register setting actually does, if
this modifies the polarity there is an inconsistency because the
inversed polarity isn't considered if the PWM is already running during
.probe().)

Fixes: acfd92fd ("pwm: lpc32xx: Set PWM_PIN_LEVEL bit to default value")
Cc: Sylvain Lemieux <slemieux@tycoint.com>
Signed-off-by: default avatarUwe Kleine-König <u.kleine-koenig@pengutronix.de>
Signed-off-by: default avatarThierry Reding <thierry.reding@gmail.com>
parent eb41f334

drivers/pwm/pwm-lpc32xx.c

+5 −5
Original line number Diff line number Diff line
@@ -117,17 +117,17 @@ static int lpc32xx_pwm_probe(struct platform_device *pdev) 
	lpc32xx->chip.ops = &lpc32xx_pwm_ops;

	lpc32xx->chip.npwm = 1;



	/* If PWM is disabled, configure the output to the default value */

	val = readl(lpc32xx->base + (lpc32xx->chip.pwms[0].hwpwm << 2));

	val &= ~PWM_PIN_LEVEL;

	writel(val, lpc32xx->base + (lpc32xx->chip.pwms[0].hwpwm << 2));



	ret = pwmchip_add(&lpc32xx->chip);

	if (ret < 0) {

		dev_err(&pdev->dev, "failed to add PWM chip, error %d\n", ret);

		return ret;

	}



	/* When PWM is disable, configure the output to the default value */

	val = readl(lpc32xx->base + (lpc32xx->chip.pwms[0].hwpwm << 2));

	val &= ~PWM_PIN_LEVEL;

	writel(val, lpc32xx->base + (lpc32xx->chip.pwms[0].hwpwm << 2));



	platform_set_drvdata(pdev, lpc32xx);



	return 0;