pinctrl: Keep enum pin_config_param ordered by name

 * 	value on the line. Use argument 1 to indicate high level, argument 0 to

 *	indicate low level. (Please see Documentation/driver-api/pinctl.rst,

 *	section "GPIO mode pitfalls" for a discussion around this parameter.)

 * @PIN_CONFIG_PERSIST_STATE: retain pin state across sleep or controller reset

 * @PIN_CONFIG_POWER_SOURCE: if the pin can select between different power

 *	supplies, the argument to this parameter (on a custom format) tells

 *	the driver which alternative power source to use.

 *	or latch delay (on outputs) this parameter (in a custom format)

 *	specifies the clock skew or latch delay. It typically controls how

 *	many double inverters are put in front of the line.

 * @PIN_CONFIG_PERSIST_STATE: retain pin state across sleep or controller reset

 * @PIN_CONFIG_END: this is the last enumerator for pin configurations, if

 *	you need to pass in custom configurations to the pin controller, use

 *	PIN_CONFIG_END+1 as the base offset.

	PIN_CONFIG_LOW_POWER_MODE,

	PIN_CONFIG_OUTPUT_ENABLE,

	PIN_CONFIG_OUTPUT,

	PIN_CONFIG_PERSIST_STATE,

	PIN_CONFIG_POWER_SOURCE,

	PIN_CONFIG_SLEEP_HARDWARE_STATE,

	PIN_CONFIG_SLEW_RATE,

	PIN_CONFIG_SKEW_DELAY,

	PIN_CONFIG_PERSIST_STATE,

	PIN_CONFIG_END = 0x7F,

	PIN_CONFIG_MAX = 0xFF,

};